To Next PageTo Next Page
Need help?Do you have a question about the Nu-Air ES100 and is the answer not in the manual?
Lists the standard items included with the HRV for installation.
Details the responsibilities of the installer for system performance and code compliance.
Describes the three commonly used and approved methods for installing the HRV.
Explains the independent duct system for supply and exhaust air.
Details using the HRV with a forced air furnace distribution system.
Discusses continuous ventilation mode with furnace fan interlocking.
Covers intermittent operation with furnace fan interlocking for supply air.
Describes a system using the furnace's return plenum for air distribution.
Details operation for simplified systems, including furnace fan interlock.
Provides guidance on using insulated ducting with a vapor barrier for outdoor connections.
Instructions for installing weather hoods, including duct connection and sealing.
Specifies separation distances and placement guidelines for fresh air and exhaust hoods.
Guidance on installing the HRV in a heated area using supplied straps.
Information on interconnecting the HRV with a forced air furnace duct system.
Recommendations for designing and installing duct runs for optimal airflow.
Step-by-step instructions for installing the HRV condensate drain assembly.
Details on interlocking the HRV with the furnace blower for proper air distribution.
Essential steps and considerations for balancing supply and exhaust air streams.
Procedure for adjusting fan speeds to balance air flows and meet capacity needs.
Overview of 12 VDC controls for the ES Series, including features and functions.
Details on ES Tx and Mx controls with touchpads and LEDs for operation modes.
Information on the ES Lumina control unit with LCD screen and humidity sensor.
Instructions for connecting ES Series controls to the HRV/ERV terminal block.
Overview of 24 VAC controls offering basic functions and easy operation.
Instructions for connecting Windsor Series and other 24 VAC controls.
Specific wiring instructions for the DSTAT-1 dehumidistat control.
Details on connecting the Win-1 dehumidistat with added features.
Wiring instructions for the Win-20 20-minute timer control.
Guidance on using remote 2-wire switching for control operations.
Explanation of status lights and their indication of the unit's operating mode.
Covers cleaning filters, fans, condensate drain, heat recovery core, and exterior hoods.
Outlines tasks for annual general servicing by an accredited contractor.
Electrical diagrams for ES170 and ES160 HRV/ERV models.
Electrical diagrams for ES100 and ES150 models.
Electrical diagrams for the ES210 model.
Details the transferable warranty for ES Series Heat Recovery Ventilators.
Warranty coverage for the HRV's recovery core against defects.
Specifies conditions and limitations not covered by the product warranty.
General
