NuAire ES-LCD - User Manual

Checking SD Card for secure location
Due to the possibility of movement during transit, we
recommend a check is undertaken to ensure that the SD
Card is located securely in its housing on the PCB before
installation commences.
This is necessary as the SD card on the PCB contains the
software for the controller and if movement of the SD card
has taken place in transit the controller will not function.
Follow the pictures below to locate the easily accessible SD
card.
Bezel
Unit containing the PCB/SD card.
Back box.
Remove the plastic
cover on the back
of PCB/SD unit.
1
11. 05. 17. Leaflet Number 671415
ES-LCD User Control
SD Card Location
Addendum to Leaflet Number 671415
SD CARD
J5
LINUX
TERMINAL
C155 C152
R121 C148
SD CARD
J5
LINUX
TERMINAL
C155 C152
R121 C148
Housing
containing
the SD card.
SD card.
Step 1: Remove the bezel and detach PCB unit from back box.
Remove plastic cover on the back of the PCB unit casing to gain
access to PCB board and SD Card.
Step 2: Locate the SD Card on PCB. Press SD Card using finger to
release from SD Card housing (as shown). Note: components are
fragile, do not use tools when adjusting SD Card.
Step 3: Press SD Card using finger to secure SD Card
into housing to ensure that the hardware & software
is connected.
Step 4: Refit the back plastic cover of the PCB unit and follow the
Installation and Maintenance instructions for full installation of the
control. In the event of a blue screen, please repeat Step 2 and 3.
The EMC Directive
2014/30/EU
The Low Voltage
directive
2014/35/EU
Nuaire: A Trading Division of Polypipe Limited Western Industrial Estate Caerphilly United Kingdom CF83 1NA
T: 029 2088 5911 F: 029 2088 7033 E: info@nuaire.co.uk W: www.nuaire.co.uk

Summary

Secure SD Card Location

SD Card Access and Securing

Steps to access, locate, release, and secure the SD card on the PCB for proper function.

Unit Reassembly

Installation Procedures

Wiring and Back Box Installation

Data Cable Installation Guidelines

Max 50m run, separate from mains cables, total length <1000m, ensure 50mm separation.

Operation and Initial Setup

Touchscreen Usage and Safety

Warnings against sharp objects and notes on screen inactivity and power-up delay.

Initial System Configuration

Assign a system name and configure heating/cooling elements fitted to the Ecosmart fan.

Timed Programmes Setup

Configuring Program Periods

Set start/end times, day, fan speed, function, and thermostat options for up to 32 periods per program.

Program Naming and PIN Protection

Naming Custom Programs

Implementing PIN Protection

Safe Cleaning Mode

Cleaning Procedure

NuAire ES-LCD Specifications

General

Brand	NuAire
Model	ES-LCD
Category	Control Unit
Language	English