To Next PageTo Next Page
Need help?Do you have a question about the NuAire LabGard ES NU-543-600S and is the answer not in the manual?
General| Model | NU-543-600S |
|---|---|
| Filter Type | HEPA |
| Supply Filter | HEPA |
| Exhaust Filter | HEPA |
| Construction Material | Stainless Steel |
| UV Light | Optional |
| Type | Class II, Type A2 Biological Safety Cabinet |
| HEPA Filter Efficiency | 99.99% at 0.3 microns |
| Power Supply | 115 VAC, 60 Hz |
| Electrical Requirements | 115 VAC, 60 Hz, 15 A |
| Certifications | NSF/ANSI 49 |
| Noise Level | 63 dBA |
Details the procedures for unpacking and positioning the biosafety cabinet for installation.
Details essential tests like HEPA filter leak test, downflow/inflow velocity, and smoke patterns.
Overview of the FlowGard™ electronic control system, its functions and components.
Describes the cabinet's operation during run mode, including warm-up and display information.
Explains visual and audible alarms, error messages, and priority of conditions.
Emphasizes aseptic techniques for effective contamination control and proper cabinet use.
Covers start-up, workspace preparation, material handling, and performing work.
Provides general guidance for cleaning laboratory equipment, including blower operation and surface disinfection.
Details required PPE, preparation, and step-by-step decontamination of the cabinet.
Explains manual and automated decontamination procedures and cabinet blower auto-run.
Procedure for replacing HEPA filters and the motor/blower assembly.
Steps for installing HEPA filters and removing the motor/blower assembly.
Covers general calibration needs and configuration parameters for the airflow system.
Procedure for calibrating the downflow velocity by adjusting blower speed.
Procedure for calibrating inflow velocity using exhaust filter choke adjustment.
Procedure for testing the integrity of the supply HEPA filter and its seals.
Procedure for testing the integrity of the exhaust HEPA filter and its seals.
Details the process for replacing the main control board and its PCB assembly.
Provides a guide to identify error messages and their corresponding correction actions.
