To Next PageTo Next Page
Need help?Do you have a question about the NuAire NU-8600 and is the answer not in the manual?
General| Brand | NuAire |
|---|---|
| Model | NU-8600 |
| Category | Accessories |
| Language | English |
Describes the 18-20 gallon water-jacket for temperature uniformity and stability.
Details the closed-loop system circulating air through a HEPA filter.
Explains the microcomputer-based control system and its components.
Describes the microprocessor-based CO2 sensor and its functionality.
Details the 304L stainless steel construction for durability and ease of cleaning.
Explains the humidity achieved via a water pan and air injection.
Describes the optional oxygen display and control system.
Provides essential safety guidelines for operating the incubator.
Defines various safety symbols used throughout the manual.
Details exterior, interior, shelf, and water pan dimensions.
Lists temperature and CO2 control ranges, accuracy, and recovery specs.
Lists the components included with the incubator upon delivery.
Information on ordering additional accessories separately.
Guidelines for visually inspecting the incubator's condition.
Details required electrical tests for safety and compliance.
Describes functional tests performed during the burn-in period.
Covers location, leveling, chamber prep, electrical, filling, and draining.
Details setup for CO2/N2 supply, pressure regulators, and connections.
Includes removing shipping ties, setting access port, and hinge reversal.
Covers sterility, humidity, and maintenance of the water jacket.
Introduction to the control system and its components.
Explains accessing menus, screens, and using active buttons.
Details functions accessed from the System Settings screen.
Covers alarms, password protection, communication, and diagnostics.
Provides descriptions of all elements on the NuTouch LCD screen.
Explains indicators for CO2, O2, and Air injection status.
Describes door ajar, USB, power interruption, maintenance, and alarm notices.
Details the power cord specifications and circuit breaker function.
Describes N2, CO2, and Air inlets and their requirements.
Covers the main power switch and communication ports.
Information on N2 and CO2 supply filters and their replacement.
Details the air inlet filter and the chamber sample port.
Describes operator interactions during normal incubator operation.
Explains standby mode and how to manage temperature, CO2, and O2 set-points.
Guides on initiating and performing diagnostic tests for system components.
Details adjustable parameters for Temperature, CO2, O2, and General settings.
Instructions for performing factory and master resets of the software.
Step-by-step guide for calibrating the chamber temperature.
How to adjust door heater duty cycles for condensation control.
Adjusting air injection length and frequency for condensation control.
Details on offset, open door, closed door, and injection CO2 calibrations.
Procedure for calibrating the O2 sensor system.
Guidelines for cleaning and maintaining the chamber interior.
Information on replacing CO2/N2 supply, air, and sensor bay filters.
Procedures for chemically decontaminating the incubator chamber.
Explains the mode activated after a power interruption.
Steps for properly shutting down the incubator.
Details the filter change notification system.
Steps for noting, clearing, and monitoring error indicators.
Error codes and suggested corrections for Temperature, CO2, and O2 systems.
Troubleshooting for general errors like door ajar, power failure, and condensation.
Details the remote alarm contact points and their function.
Information on 4-20mA output, RS-485, and USB port capabilities.
Covers electrical, operational, environmental, installation, and EMC specifications.
Specifies the heat rejection rate of the incubator.
Provides instructions for the proper disposal and recycling of the incubator.
