To Next PageTo Next Page
Need help?Do you have a question about the NuAire NU-5810 and is the answer not in the manual?
General| Brand | NuAire |
|---|---|
| Model | NU-5810 |
| Category | Accessories |
| Language | English |
Details the design and capacity of the DHD inner chamber.
Describes the air circulation and HEPA filtration system for monitoring CO2.
Explains the microcomputer-based control system and its components.
Details the microprocessor-based CO2 induction sensor and its calibration.
Describes the outer shell and inner chamber materials and construction.
Explains humidity control methods for different models.
Details the function and location of the cabinet ventilator fans.
Provides essential safety guidelines for operating the incubator.
Lists and defines various symbols used in the manual for hazard communication.
Identifies the specific models covered by this manual and their decontamination capability.
Provides exterior and interior dimensional specifications for the incubator models.
Details temperature and CO2 control performance specifications and ranges.
Lists the standard accessories and components included with the incubator.
Outlines the visual checks performed on the incubator to ensure cleanliness and finish.
Describes electrical safety tests including leakage and grounding continuity.
Details the operational tests conducted to verify incubator performance and control systems.
Provides instructions on how to handle and report visible or concealed shipping damage.
Advises on selecting a suitable location for the incubator considering performance and procedures.
Explains the procedure for leveling the incubator using the adjustable feet.
Details how to prepare and install shelves and the water pan.
Covers electrical connection requirements and safety precautions.
Describes the connection of the air inlet and its HEPA filter.
Provides instructions for connecting CO2 and N2 gas supplies and regulators.
Guides on properly setting up the access port for cable passage.
Discusses chamber sterility and initial cleaning procedures before use.
Explains how humidity is achieved and maintained in the incubator.
Introduces the incubator's control system and operator interface.
Describes the functions and display elements of the NuTouch LCD screen.
Details the components and connections located on the rear control panel.
Details the components and connections located on the front panel.
Guides the user on interacting with the incubator during normal operation.
Explains how the incubator operates in standby mode and user interaction.
Provides procedures for running diagnostics and checking system functions.
Provides detailed steps for calibrating the chamber temperature sensor.
Explains how to adjust heater duty cycles to control condensation or uniformity.
Guides on adjusting air injection settings to manage condensation.
Outlines various methods for calibrating the CO2 sensor.
Describes methods for calibrating the relative humidity sensor.
Details the procedure for calibrating the O2 sensor.
Explains the procedures for performing 95°C humidified and 145°C dry decontamination cycles.
Describes chemical decontamination methods for the chamber.
Explains the incubator's behavior and recovery after a power interruption.
Provides instructions for properly shutting down the incubator.
Details the filter replacement notification system and how to respond.
Lists error codes and their corresponding checks and corrections for the temperature system.
Lists error codes and their corresponding checks and corrections for the CO2 system.
Lists error codes and their corresponding checks and corrections for the RH system.
Lists error codes and their corresponding checks and corrections for the O2 system.
Lists general error indicators and their troubleshooting steps.
Describes the remote alarm contacts and their function for external monitoring.
