SL1008 - Indice A 66/200
To Capture Videos, make sure display reads VIDEO:
Once in MANUAL mode, if the display does not read VIDEO then:
• Slide the switch to the SET position, the status display will
show the camera current status.
• Press the [M] button once to enter the Manual
programming mode.
• The word “PIR” will be blinking, press [OK] to confirm the
camera’s operation is PIR detection.
• Press the [UP] or [DN] button until the word “VIDEO” is
blinking.
• Press the [OK] button once to confirm and then press the
[M] button to exit.
• Then slide the switch from the SET position to MANUAL,
and close the cover.
Now, the status display will count down 60 seconds for you to
leave the coverage area and then the camera will capture
images or videos at each PIR triggering.
NOTE: The time between motion detection and the
camera taking the pictures may vary due to lighting
conditions, program settings, and battery power level.
The IR Emitter will only be activated in low light
conditions.
To Next Page
Loading...
