SL1008 - Indice A 67/200
Using the Camera in Time Lapse Mode
• Mount the camera on a tree, wall or other sturdy object
using the supplied mounting strap.
• Open the cover and slide the switch to the SET position.
• Press the [M] button once to enter the Manual
programming mode, the word “PIR” or “TLS” will be
blinking.
• Press the [UP] button until you see the word “TLS”
blinking.
• Press the [OK] button once to confirm and then press the
[M] button to exit.
• For other settings, please follow the “Camera setup and
program – Setting the Time Lapse Mode” above to set
the camera into Time Lapse Mode.
• Then slide the switch from the SET position to MANUAL,
and close the cover.
Now, the status display will count down 60 seconds for you to
leave the coverage area and then the camera will start capturing
photos once reached the programmed start time, and stop at
the programmed end time.
To Next Page
Loading...
