Need help?Do you have a question about the Numark M6 and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| EQ | 3-band |
| USB | Yes |
| Crossfader | Replaceable |
| Outputs | Master (RCA), Record (RCA), Booth (RCA) |
Connects the mixer to a power outlet using the included adapter. Power should be off during connection.
Sets the AC input voltage for the mixer, typically 100-120V or 220-240V.
Turns the mixer on and off. Turn on after inputs are connected and off before amplifiers.
Connects the grounding wire from turntables to prevent hum or buzz.
Connects phono-level devices like turntables to the mixer.
Connects line-level devices such as CD players or audio interfaces.
Outputs the Record mix to computer or sends computer audio to Channel 3.
Connects an additional 1/4" microphone to Channel 4.
Low-impedance XLR output for connecting to speaker or amplifier systems.
Connects to speaker or amplifier systems using standard RCA cables.
Connects to a booth monitoring system using standard RCA cables.
Connects to a recording device like a CD recorder or tape deck.
Indicates when the mixer is powered on.
Selects the input source for each channel.
Displays the audio level of each corresponding channel.
Adjusts the pre-fader and pre-EQ gain level for each channel.
Adjusts the high frequencies of the corresponding channel.
Adjusts the mid-range frequencies of the corresponding channel.
Adjusts the low frequencies of the corresponding channel.
Sends pre-fader audio to the Cue Channel for headphone monitoring.
Adjusts the audio level of the corresponding channel.
Selects which input channel is heard when the crossfader is moved.
Blends audio between channels assigned to the left and right of the crossfader.
Adjusts the slope of the crossfader curve for smooth fade or sharp cut.
Connects 1/4" headphones for cueing and mix monitoring.
Adjusts the audio level of the Cue channel.
Splits or blends Cue and Program audio in the headphone channel.
Mixes between Cue and Program audio in the headphone channel.
Connects a microphone using an XLR cable.
Adjusts the audio level of the microphone signal.
Adjusts the high frequencies of the microphone channel.
Adjusts the mid-range frequencies of the microphone channel.
Adjusts the low frequencies of the microphone channel.
Turns the microphone input on or off, with a TALKOVER function.
Adjusts the output volume of the Program mix.
Displays the audio level of the Program mix.
Adjusts the Program mix for stereo or mono operation.
Adjusts the balance of right to left audio in all outputs.
Adjusts the Booth output level.
Instructions for setting up the M6 USB with computer audio software for playback and recording.
To Next Page
