Numark MIXTRACK PLATINUM FX - Page 9

3. REMOVAL OF 3.5 INCH PCB ASSEMBLY. (Fig.3)
(A) TAKE APART THE 2 PCS WHEEL PLATE.
(B) REMOVE THE 12 PCS SCREWS BEFORE REMOVAL OF WHEEL FIXED HOLDER.
(C) REMOVE 2 PCS NUT(M16) AND 4 PCS SCREWS AND 2 PCS C RING BEFORE REMOVAL OF TFT
HOLDER.
(D) TAKE APART THE 2 PCS TFT HOLDER BEFORE REMOVAL OF 3.5 INCH PCB ASSEMBLY.
Fig.3