Numark MIXTRACK PLATINUM - Front and Rear Panel Connections; Display Information

5
Front Panel
1. Headphone Output: Connect headphones to these
1/4” (6.35 mm) and 1/8” (3.5 mm) jacks for
monitoring the signal. The headphone volume is
controlled using the Cue Gain knob.
2. Microphone Input: Connect a standard dynamic
microphone to this 1/4” (6.35 mm) jack.
3. Mic Gain: Adjusts the level for the microphone input.
Rear Panel
1. Master Output (RCA): Use standard RCA cables to
connect this output to speakers or an amplifier
system.
2. USB: Sends USB MIDI data to control various
software parameters.
Display
1. Platter Position: Displays the current
track position.
2. Time Bars: Provides a visual reference of
the time remaining for the current track.
When the track is almost over, the bars
will flash as a warning.
3. Active Deck: Indicates the currently
active deck.
4. Time Remaining: Displays the time
elapsed or time remaining for the current
track.
5. BPM: Displays the current BPM for the
selected track.
6. Pitch Adjust: Indicates the direction to move the Pitch Fader to match the current
track’s BPM with the track on the opposite deck.
7. Keylock: This icon illuminates when Keylock is active for the current deck. See the
Serato DJ Intro manual to learn about Keylock.
8. Slip: This icon illuminates when Slip mode is active for the current deck. See the Serato
DJ Intro manual to learn about Slip mode.
1
2
3
1
2
1
2
3
4
5
6
7
8