Numark NS7 III - Attach Display Unit; Install Drivers and Software

4
2. Attach the Display Unit
1. With the screens facing up and slightly toward you, place the display unit over the two
brackets on the rear panel (which would typically hold a laptop computer stand). Make
sure the two brackets are securely inserted into the holes under the display unit.
2. Using the small display USB cable (included), connect the “NS7” USB port on the display
unit to the USB port on NS7III’s rear panel.
3. Using the small display power cable (included), connect the display power input (DC In)
to the display power output (DC Out) on NS7III’s rear panel.
3. Install the Drivers and Software
Drivers (Windows users only): Download and install the latest drivers
Software: Download and install the latest version of Serato DJ