Numark NVII User Manual

16
11. Auto-Loop / Beat-Jump Buttons: These eight buttons correspond to the deck's eight
pads while in Auto-Loop Mode. In that mode, press one of the pads to trigger an auto-
loop of the corresponding length. See Top Panel > Pad Mode Controls > Auto / Roll to
learn more.
When Beat Jump is activated, the bottom four pads are used for Beat Jump controls. See
Top Panel > Navigation Controls > Beat Jump to learn more.
12. Effect Name: In Multi-FX Mode, the view will show three effects with one parameter
knob each.
In Single-FX Mode, the view will show one effect name with three parameter knobs.
To switch between Single-FX Mode and Multi-FX Mode, press and hold Shift and press
the Beat button.
To move to the next effect (in either mode), press and hold Shift and then press the FX
Button under the effect name. Alternatively, press and hold Shift and then turn the FX
Knob under the effect name to move quickly through the list.
13. Effect Parameter: In Multi-FX Mode, the view will show three effects with one parameter
knob each, which corresponds to the main parameter of that effect. To adjust each
effect, turn the FX Knob below it.
In Single-FX Mode, the view will show one effect name with three parameter knobs. To
adjust each parameter, turn the FX Knob below it.
To switch between Single-FX Mode and Multi-FX Mode, press and hold Shift and press
the Beat button.
14. Effect Beats Multiplier: This number determines the timing or rate of the effects, based
on the BPM.

Numark NVII Specifications

General

Controller Type	DJ Controller
Number of Decks	4
Channels	4
EQs	3-band EQ per channel
MIDI	Yes
Pitch Control	Yes
Pads	16 x Velocity-sensitive Pads
Inputs	1 x 1/4" Mic
USB	1 x Type B
Software	Serato DJ
Jog Wheels	2
Faders	Crossfader
Audio Interface	24-bit
Weight	7 lbs
Outputs	1 x 1/4" (headphones), 1 x 1/8" (headphones)