QUICK SETUP GUIDE (ENGLISH)
NORMAL
FILTERS
FLANGER
AUTOPAN
L R
AUTOCUT
FILTERED
LOPASS
VARI-CUT
RATE
RATE
DJ HEADPHONE
AUDIO RECORDER
POWER
MIXER
1. Make sure all items listed on the front of
this guide are included in the box.
2. READ SAFETY INSTRUCTION BOOKLET
BEFORE USING THE PRODUCT.
3. Study this setup diagram.
4. Note: This turntable can be used as a
standalone unit, as well as with the items
listed in the quick setup diagram.
5. Make sure all devices are turned off and all
faders and gain knobs are set to “zero”
6. Connect all stereo input sources as
indicated in the diagram.
7. Connect the stereo output devices to power
amplifier(s), tape decks, and/or other audio
sources.
8. Plug all devices into power.
9. Switch everything on in the following order.
•Turntable
•Mixer (not included)
•last, any amplifiers or output devices (not
included)
10. When turning off, always reverse this
operation by,
•turning off amplifiers (not included)
•mixer (not included)
•Turntable
11. Go to http://www.numark.com for product
registration.
More information about this product may be
found at http://www.numark.com
BATTERY INSTALLATION
This product can be powered by 6 “D” Cell batteries. They should be loaded as show above, with the positive
end toward the handle.
To Next Page
Loading...
Need help?
General
