Numark X5 - Cueing and Monitor Controls; Headphone Monitoring and Level Adjustment; Channel Cueing and Master Mix Selection; Crossfader Controls

4-1. DISASSEMBLE THE MIC AND PHONE PCB ASSEMBLY . (Fig.4-1)
(A) REMOVE 2 NUTS AND 2 WASHERS BEFORE REMOVING OF THE MIC AND PHONE PCB ASSEMBLY.
(B) REMOVE 2 CABLES ON THE MIC AND PHONE PCB ASSEMBLY.
(Fig.4-1)
5. REMOVING OF THE MAIN PCB ASSEMBLY.
5-1. REMOVING OF THE KNOBS, FIXED HOLDERS AND GROUND PLATES.
(Fig.5-1)
(A) REMOVE 17 KNOBS.
(B) REMOVE 5 FIXED HOLDERS.
(C) REMOVE 2 GROUND PLATES.
(Fig.5-1)