To Next Page
E
esharpAug 10, 2025
Why is the vacuum not working on my Numatic Scrubber?
- JJennifer WatsonAug 10, 2025
If the vacuum on your Numatic Scrubber isn't working, the waste water tank might be full, so you should empty it. Also, check the fuse.
Why is the vacuum not working on my Numatic Scrubber?
If the vacuum on your Numatic Scrubber isn't working, the waste water tank might be full, so you should empty it. Also, check the fuse.
Why is the Numatic HGB 3045/55 not picking up water properly?
If your Numatic Scrubber isn't picking up water effectively, several factors could be at play. First, the waste water tank might be full, so empty it. Next, check for blockages in the vacuum hose, debris basket filter, and separator filter; remove and clean them if necessary. Ensure hose connections are tight. A poor separator seal should be cleaned and refitted, but a damaged seal, vacuum hose, or floor tool blades require replacement (contact service dept). Also, low battery charge can cause this issue, so recharge the batteries.
How to troubleshoot a Numatic HGB 3045/55 that will not turn on?
If your Numatic Scrubber isn't starting, check these potential causes: * Missing or blown fuses: Fit or replace the fuse. * Low battery charge: Charge the batteries. * Connected and charging: Disconnect the charger before operation.
What to do if the Numatic HGB 3045/55 has little or no water flow?
If your Numatic Scrubber has little to no water flow, consider these possibilities: The clean water tank may be empty, so fill it. The clean water tank filter might be blocked or clogged, so remove and clean it. Ensure the water flow is switched on. Also, check if the brush deck is raised; if so, lower it.
How to fix the brush function on a Numatic Scrubber?
If the brush or scrub function isn't working on your Numatic Scrubber, check if the brushes are fitted correctly. Also, check the fuse.
What to do if Numatic Scrubber stops while in use?
If your Numatic Scrubber stops while operating, it might be due to too much load on the brush system. Decrease the brush load to better suit the floor type.
General| Model | HGB 3045/55 |
|---|---|
| Category | Scrubber |
| Working Width | 450 mm |
| Brush Size | 450 mm |
| Weight | 131 kg |
| Dimensions | 1270 x 520 x 1070 mm |
| Brush Width | 450 mm |
