How to increase water flow on Numatic Scrubber?
If your Numatic Scrubber isn't providing enough water flow, make sure the clean-water tank is full. Also, check the water flow setting and adjust the tap as needed. Finally, examine the tank filter for any blockages and clean it if necessary.
Why does my Numatic TTB1840NX Scrubber keep stopping while I'm using it?
If your Numatic Scrubber stops unexpectedly during operation, it might be due to excessive load on the brush system. If the cut-out engages, the surface may be too rough, and you might need a different machine.
Why is my Numatic TTB1840NX not picking up water well?
If your Numatic Scrubber isn't picking up water effectively, here are a few things to check: * First, empty the waste-water tank. * Second, inspect the vacuum hose for any clogs or blockages; remove and clean it if necessary. * Third, ensure all hose connections are secure and tight. * Fourth, check the debris basket filter and separator filter for blockages; remove and clean them if needed. * Fifth, make sure the separator seal is clean and properly fitted. Contact service if the seal is damaged or the vacuum hose is split. Also, contact service if the floor-tool blades are damaged.
Why is the brush not working on my Numatic Scrubber?
If the brush or scrub function isn't working on your Numatic Scrubber, start by checking if the brushes are properly fitted. If the brushes are overloaded, reset the machine.
How to fix a Numatic TTB1840NX Scrubber that won't turn on?
If your Numatic Scrubber won't turn on, make sure the battery is correctly inserted. If the battery is low, recharge it. If the battery is faulty, replace it.
Guide on attaching the brush or pad and securing the floor-tool to the machine's carrier.
Instructions for filling the clean water tank and checking the water level.
Details on how to adjust the water flow rate for cleaning.
Explanation of error codes indicated by flashing battery lights on the control panel.
Procedure for adjusting the floor-tool position using the lever near the handle.
Steps and tips for operating the scrubber dryer, including water flow and scrubbing techniques.
Instructions for emptying waste and clean water tanks and cleaning the separator.
Steps for removing, replacing, and refitting the squeegee blades on the floor-tool.
Details on the machine's rating label and WEEE disposal regulations.
Recommended personal protective equipment for operating the machine.
Guidance on daily and weekly inspection and maintenance tasks for the machine.
Key instructions on what to do and not to do for safe and effective machine operation.
List of available spare parts and a schematic diagram of the machine's components.
To Next Page
General