Numatic TTB1840NX - Machine Operation; Raising and Lowering the Floor-tool; Machine In Use

9
T 01460 68600
To raise the oor-tool, ensure the oor-tool carrier is central to the machine.
Lift the lever near the base of the handle and lock into position.
Raising/Lowering the Floor-tool
Machine Operation
WHEN HANDLING CHEMICALS
Always ensure that chemical manufacturer’s safety guidelines are followed.
Only use chemicals recommended for use in auto scrubber-dryers.
!!
IMPORTANT
Do not operate machine unless the Operator Manual has been read
and fully understood.
!!
To operate, set water ow rate tap, lower the oor-tool, press the vacuum / water switches, pull
trigger(s).
The waste water is then retrieved by the suction oor-tool.
Overlap each scrubbing path by 10cm to ensure an even clean.
Do not operate the machine on slopes that exceed (2%),when full.
On heavily soiled oors use a ‘double scrub’ technique.
First pre-scrub the oor with the oor-tool in the raised position,
allow the chemical time to work then scrub the area a second
time with the oor-tool lowered.
If streaking occurs wipe oor-tool blades clean.
NOTE: Care must be taken to reduce speed when
cornering or when manoeuvring around obstacles
Machine In Use