1918
INSTALLATION
INSTALLATION
Fitting Restraint to Base
To Install
First make sure there is
nothing in or on the base
(blankets, toys etc).
These may stop the restraint
from latching securely.
Lower the restraint down
into the base. Listen for a
"CLICK" from the latches in
the base.
Pull up on the restraint to
ensure it is securely latched.
To Release
Lift the restraint with one
hand while pulling up on the
release latch at the back of
the base.
"CLICK"
WARNINGS – Top Tether
THIS RESTRAINT MUST BE ATTACHED TO A CHILD
RESTRAINT UPPER ANCHORAGE POINT IN THE CAR.
REFER TO CAR OWNERS HANDBOOK FOR LOCATION
OF ANCHORAGE POINTS.
REFER TO A CHILD RESTRAINT FITTING STATION IF NO
ANCHORAGE POINTS ARE IN THE MOTOR CAR.
THIS RESTRAINT IS NOT SUITABLE FOR USE WHERE
THE TOP TETHER STRAP MAY FALL INTO A SPLIT IN
THE SEAT BACK OR OFF THE SIDE OF THE SEAT.
Always secure the loose end of the top tether strap to
prevent it hanging out of the car or being accessible by
the child.
It should be stored in the bag provided on the end of the
strap.
Do not use the child restraint where this strap may fall into
a split in the seat back or off the side of the seat.
ALWAYS ATTACH HOOK AND REMOVE SLACK.
CAUTION: CHILDREN CAN BE INJURED OR RE-
STRAINTS AND TOP TETHER STRAP DAMAGED BY
UNSECURED CARGO IN A COLLISION.
SECURE OR REMOVE HAZARDOUS CARGO BEFORE
USING THIS CHILD RESTRAINT.
In some vehicles without a xed parcel shelf an
extension tether strap may be required. These are
available in several different lengths and can be
obtained from child restraint retail outlets.
To Next Page
Loading...
Need help?
General
