Nuna Exec - Seat Cover Removal; Checklist before Removing Seat Cover; Remove Head Support Cover

Seat Cover Removal
Removing the seat cover involves removing the
cover from the head support, the leg rest, and the
entire child restraint.
Checklist Before Removing Seat Cover
Raise head support to highest position (p.34)
Loosen/unbuckle harness and chest clip (p.26).
Remove harness pads, head insert, and infant
insert (p.32–34).
Unhook tether from back of seat (p.50).
Remove Head Support Cover
1 - Undo the snaps on the bottom of the head
support cover.
2 - Undo the upper and lower snaps (location
indicated by the four arrows) in the center of
the head support cover.
3 - Gently pull the cover out of the retaining
channel along the edge of the head support.
4 - Undo the snaps around the harness straps (1).
Slide the straps out to remove the head
support cover (2).
Take care when removing head support
cover so as not to damage the energy
absorbing foam underneath.
WARNING: Do not attempt to disassemble
the child restraint. Only perform steps shown in
this manual.
1
2
3
4
1
2
3 EXEC
™
care instructions 4EXEC
™
care instructions