2423
EN
EN
Securing child
After the child is placed into the seat, check whether the
Shoulder Harness Straps are at proper height.
1 While pressing the adjustment button located at the front of
the infant child restraint, pull completely the two Shoulder
Harness Straps of the infant child restraint.
(22)
2 Unlock the buckle of the harnesses by pressing the red
button. (23)
3 Place the child into the infant child restraint and lock the
buckle. (25)Please refer to. (24)
4 Tighten the shoulder harness straps by pulling the
adjustment webbing. (26)
Make sure the space between the child and the Shoulder
Harness Straps is about the thickness of one hand.
Detach the snaps on
the head support to
remove the head
portion of the insert.
We recommend
using the full infant
insert while the baby
is under 60 cm or
until they outgrow
the insert. The infant
insert increases side
impact protection.
Remove the head
support portion of
the infant insert
when the child’s
head no longer fits
comfortably.
Remove the body
portion of the infant
insert when the
infant’s shoulders no
longer fit comfortably.
The cushion can
be used separately
without being
attached to the
insert to bolster
the infant's back
for more comfort.
Remove the infant
insert cushion by
detaching the snaps
to allow more space
when the infant does
not fit comfortably.
1
2
Use Infant Insert
Canopy
1 Unzip the zipper behind the front canopy bow. (27)
2 Pull the canopy out of the compartment. (28)
3 Attach the magnets on each corner to the front of the infant
child restraint. (29)
4 The zipper on the back of canopy can be opened for
ventilation. (30)
Cold Weather Boot
1 Cover the cold weather boot onto the infant child restraint,
then attach the both sides to the infant child restraint with
plastic pieces. (31)
2 You can use cold weather boot and canopy simultaneously.
(32)