PIPA instructions
14
13
EN
EN
PIPA instructions
Crotch belts
Identify crotch belt slot that will achieve a snug fit.
Change crotch belt slot if necessary. (12)
1 - Smaller babies use this position. Crotch belt is
threaded through rear slot and up through front
slot as shown. (13)
2 - Medium sized babies use this position. Crotch belt
is threaded into rear slot as shown. (14)
3 - Larger babies use this position. Crotch belt is
threaded through front slot as shown. (15)
Handle adjustment
1 - The handle of the infant child restraint can be
adjusted to 3 positions.
Baby chair position. (16) -2
Rocking position. (16) -1
Position for car, hand or stroller transportation.
(16) -3
2 - To adjust the handle positon, squeeze handle
buttons on both sides to release it. (17) -1
3 - Rotate handle until it clicks into any of the 3
positions. (17) -2
Installation without base
1 - Place the infant child restraint onto the vehicle
seat where you wish to put it. Pull the vehicle
safety belt out and lock it into the vehicle buckle,
sliding the vehicle lap belt into the side guides of
the infant child restraint. (18)
The child restraint can not be used if the vehicle
safety belt buckle (female buckle end) is too long
to anchor the child restraint securely. (18)-1
2 - Pull the diagonal belt behind the front end of the
child restraint and then through the blue belt
guide. (19)
3 - Pull the vehicle shoulder belt to fasten the infant
child restraint tightly and securely. (20)
4 - Level line on carrier must be level to the ground
when the child restraint is installed. (34)
Tension the vehicle safety belt as much as
possible, checking that it is not loose or twisted.
After installing the infant child restraint, always
check that the vehicle belts are routed correctly
and securely fastened into the vehicle buckle. (21)
Securing child
Foam inside infant insert is present to ensure that
harness fits child properly. Infant insert must be used
for children 0-6 months.
After the child is placed into the seat, check whether
the Shoulder Harness Straps are at proper height.
1 - While pressing the adjustment button located
at the front of the infant child restraint, pull
completely the two Shoulder Harness Straps of
the infant child restraint. (22)
2 - Unlock the buckle of the harnesses by pressing
the red button. (23)
To Next Page
Loading...
