PIPA instructions
12
11
EN
EN
PIPA instructions
Product Use
Installation Concerns
DO NOT install this Infant child restraint on vehicle
seats with 2-Point Retractor Safety Belts without the
Base. (1)
This Infant child restraint is suitable for vehicle seats
with a 3-point Retractor Safety Belt (with or without
base) ONLY. (2)
DO NOT install this Infant child restraint on vehicle
seats that face sideways (3) or rearward (3) with
respect to the moving direction of the vehicle.
DO NOT place rear-facing child restraint on front seat
with air bag. Death or serious injury may occur. (3)
Please reference vehicle owner’s manual for more
information.
It is recommended to install this Infant child restraint
on the rear vehicle seat. (3)
DO NOT install this Infant child restraint on vehicle
seats unstable during installation.
Shoulder harness position
Check that Shoulder Harness Straps are set at the
proper height. Please choose the proper pair of
shoulder harness slots according to the child’s height.
Shoulder Harness Straps must go into the harness
slots nearest to your childs shoulders (4), but not
above the shoulder line. (5)
If the Shoulder Harness Straps are not at proper
height, the child might be ejected the infant child
restraint if there is a crash.
Shoulder harness
straps height adjustment
Use extreme care in threading the Shoulder Harness
Straps according to the figure. If the Shoulder
Harness Straps are not secure, they will not protect
your baby.
The ends of the Shoulder Harness Straps must hang
in front of the junction plate.
Ensure that the shoulder harness straps are not
twisted before reassembling the ends onto the
junction plate.
1 - Press the adjustment button at the front of the
seat and pull on the shoulder harnesses to loosen
them. (6)
2 - At the back of the seat, take the harness ends off
the metal junction plate. (7)
3 - Pull the harnesses through the slots in the seat.
Insert them into the appropriate set of slots. (8)
4 - Reassemble the harness ends onto the junction
plate. (9)
The ends of the Shoulder Harness Straps have two
loops.
For a smaller baby, use the upper shoulder
harness loops. (10)
For a larger baby, use the end shoulder harness
loops. (11)
To Next Page
Loading...
