PIPA instructions
16
15
EN
EN
PIPA instructions
3 - Place the child into the infant child restraint and
lock the buckle. (24) Please refer to (25).
4 - Tighten the shoulder harness straps by pulling the
adjustment webbing. (26)
Make sure the space between the child and the
Shoulder Harness Straps is about the thickness of
one hand.
Canopy
1 - Unzip the zipper behind the front canopy bow. (27)
2 - Pull the canopy out of the compartment. (28)
3 - Attach the magnets on each corner to the front of
the child restraint. (29)
Detach canopy and seat pad
1 - To disassemble the canopy, press the button in the
canopy mount and pull the canopy bow out. (30)
2 - Pull the fastening pieces underneath the edge of
the seat out. (31)
3 - Pull the harness out of the metal junction plate. (7)
4 - Remove the seat pad from the adjustment button
as shown in. (32)
5 - Remove the seat pad from the Stroller release
button as shown in. (33)
Cleaning and Maintenance
After child is older than 6 months, please remove the
foam from the infant insert and store it somewhere
your child cannot access it.
Please wash the soft goods with cold water under
30°C.
Do not iron the soft goods.
Do not bleach or dry clean the soft goods.
Do not use undiluted neutral detergent, gasoline
or other organic solvent to wash the infant child
restraint. It may cause damage to the infant child
restraint.
Use only mild detergent, water and a soft cloth to
clean the child restraint shell, handle and harness
straps.
Do not twist the soft goods to dry with great force. It
may leave the soft goods with wrinkles.
Please hang dry the soft goods in the shade.
Please remove the infant child restraint from the
vehicle seat if not in use for a long period of time.
Put the infant child restraint in a cool, dry place and
somewhere your child can not access it.
©2018 Nuna International B.V. Nuna and all associated logos are
trademarks.
To Next Page
Loading...
