1413
REBL basq Instructions
REBL basq Instructions
EN
EN
Make sure that both ISOFIX connectors are securely
attached to their ISOFIX anchor points. There should
be two audible clicks and the colors of the indicators
on the both ISOFIX connectors should be completely
green. (6)-1
Check to make sure the Enhanced Child Restraint
is securely installed by pulling on the both ISOFIX
connectors.
5 - There are 9 adjustable positions for ISOFIX. Press
the ISOFIX adjustment button and push the base
back against the vehicle seat until tight.
6 - After placing the Enhanced Child Restraint on the
vehicle seat, extend the load leg to floor. (7), The
load leg indicator will show green when installed
correctly, red means it is installed incorrectly. (7)
The load leg has 24 positions. When the load leg
indicator shows red this means the load leg is in the
wrong position.
Make sure the load leg is secure by pressing
down on the front of the Enhanced Child
Restraint.
To shorten the load leg, squeeze the load leg
release button and pull the load leg upwards.
7 - To remove the Enhanced Child Restraint, press
the ISOFIX adjustment button (5)-1 and pull the
base away from the seat, then while squeezing
the button and secondary lock on the ISOFIX
connectors remove from the vehicle. (8)
Product Use
DO NOT install this Enhanced Child Restraint on
vehicle seats that face sideways (1) or rearward (1)
with respect to the moving direction of the vehicle.
DO NOT place rear-facing Enhanced Child Restraint
on front seat with air bag. Death or serious injury may
occur. (1) Please reference vehicle owner’s manual for
more information.
It is recommended to install this Enhanced Child
Restraint on the rear vehicle seat. (1)
This Enhanced Child Restraint is suitable for vehicle
seats with i-Size ISOFIX anchor points. (2)
DO NOT install this Enhanced Child Restraint on
vehicle seats unstable during installation.
Installation
1
- Unfold the load leg from the storage
compartment. (3)
2 - Fit the ISOFIX guides into the ISOFIX anchor
points. (4) The ISOFIX guides can protect the
surface of the vehicle seat from being torn. They
will also guide the ISOFIX connectors.
3 - Press the ISOFIX adjustment button on either side
of the base, then pull out the ISOFIX connectors.
(5)
4 - Line up the ISOFIX connectors with the ISOFIX
guides, and then click both ISOFIX connectors
into the ISOFIX anchor points. (6)
To Next Page
Loading...
Need help?
General
