Shandong Nuoman Engineering Machinery Co.,Ltd
Business Room, No. 7, Zhongshan West Road, Gulou Street Office, Yanzhou Dist., Jining, Shandong, CN
TEL/Fax:+8618266821667 Whatsapp/Wechat:+8618266821667
possible park on a firm, flat and
level surface; if not, park across a
slope. Set the parking brake(s),
lower the implements to the ground,
remove the key from the ignition
and lock the cab door (if equipped)
and chock the crawlers or the
wheels.
3. AFTER OPERATION
Before leaving the machine,
• Bring the excavator to hard even
ground.
• Lower the attachments and the
dozer blade on the ground.
• Stop the engine.
• Lock all control levers.
• Remove the key.
4. SAFE LOADING AND
TRANSPORT OF THE
EXCAVATOR
1.Observe all regulations concerning
the transport of excavators on public
roads.
2.Use adequately long and robust
ramps when loading on a truck, (for
details see 'TRANSPORTING THE
EXCAVATOR ON A TRUCK")
3.Do not change the running direction
and to avoid a tipping over, do not try
to swing the attachment crosswise to
the loading ramps.
4.After loading of the excavator on a
truck, engage the swing lock pin.
Lower the attachment on the loading
plane and release the pressure from
the hydraulic system.
Block the crawlers with blocks and wire
down the excavator. After loading the
excavator on a truck, tie down the
undercarriage of the excavator with a
strong steel wire on the truck.
5. Do not brake abruptly with the
excavator loaded. Fatal accidents could
happen.
6. If the excavator is to tow another
machine, the load must be smaller than
the strength of the hook.
5.
MAINTENANCE
Before doing maintenance work on the
excavator, place the machine on even
solid ground, lower the attachments on
the ground, stop the engine and release
the cylinder pressure by actuating the
levers. When dismantling hydraulic
parts, make sure that the hydraulic oil
has cooled down sufficiently to avoid
burns.
Start maintenance work carefully, e.g.
loosen screws slowly so that oil will not
squirt out.
1. Before doing work on the engine,
the exhaust system, the radiator and
the hydraulics, let the excavator cool
down sufficiently.
Max. drawbar pull at
coupling hook
Max. vertical load at
coupling hook
To Next Page
Loading...