NUOVA ELETTRONICA DSP LASER AP

Need help?

Do you have a question about the NUOVA ELETTRONICA DSP LASER AP and is the answer not in the manual?

Summary

Safety precautions

Checks

Instructions for checking operating voltage and immediate actions upon liquid/object penetration.

Planning safety measures

Overview

System composition

Signals and plate data

System Characteristics and Installation

Mechanical installation

Details the mechanical installation requirements for the MCS module and DSP LASER AP TX/RX units.

Electric connection

Explains the electric connections, signal management, and wiring for MCS and associated devices.

Commissioning

Power supply and first functional verification

Steps to power on the system and perform initial checks on display, laser, and receiver LEDs.

List, description and programming of MCS parameters

Details the various programmable parameters (Type A, B, C) for device configuration and safety functions.

System Test

Outlines the procedure for executing a system test by programming specific MCS parameters.

First installation of TX and RX

Instructions for the optical alignment of the DSP LASER AP TX and RX units to the press brake's upper tool.

Verification of the stop distance

Explains the mandatory process for verifying the machine's stop distance after initial setup or periodically.

Verification of Low Speed and High Speed

Speed change point and Automuting

Blanking Modality of DSP LASER AP

Residual risks

Risks typical of the laser source

Blanking

Risks deriving from dangers of mechanical type

Use

Light Indicators

Verification of stop distance

Mandatory procedure to verify the machine's stop distance at each switch-on.

Sheet Edge Acquisition

Adjustment after the tool change

Maintenance

Alarms;errors and possible solution of the problems

Removal and reinstallation after the repair

Technical characteristics