50
ENGLISH
Before starting to use the appliance, the operator
must be sure to have read and understood the
safety prescriptions contained in this booklet.
6.1 TURNING THE
MACHINE ON
• Plug the machine in and position the
main switch on “”.
• The state of the machine will be shown
by the signal:
• The unlit display will read:
The machine is not operative in that the
main switch only supplies the electronic
card.
Automatic On/Off NOT PROGRAMMED
: make sure that the general switch is
always on the position “”.
The state of the machine will be shown
by the signal:
OFF
6.
USE
: press the key for 2
seconds, the buzzer will beep,
the display will light up to indi-
cate the release of the EPROM
for about 1 second.
The control unit will start up an
auto diagnosis cycle to check
the functions, all the selection
keys will light up.Once the
check is completed the display
will read:
with the day and time. When
110°C has been reached, the
heating message will disap-
pear and will be replaced by
the words:
:
on completion of the check up all the
selection keys are activated.
HEATING
MACHINE READY
OFF
: press the key for 2
seconds; the machine will turn
off and the display will read:
Automatic On/Off PROGRAMMED
: make sure that the general switch is
always on the position “”.
The state of the machine will be shown
by the signal:
The control unit will perform an
auto diagnosis of all functions
and all of the selection keys
will light up.
Once the diagnosis is com-
plete, the display will read as
follows:
with the date and time. Once
the temperature of 110°C has
been the word “Heating” will
disappear to be replaced by:
: once the auto diagnosis has been com-
pleted all the keys are activated.
HEATING
MACHINE READY
To Next Page
Loading...
