12
WARNING
Those machines are equipped with device which protects the motor from overheating.
When this device is engaged, do not attempt to operate the machine: isolate the machine
from the power supply and eliminate the cause of the trouble before re-starting.
3.1. PRECAUTIONS AND SAFETY FEATURES
Machine design has taken into account all reasonable user safety precautions; nevertheless,
particular conditions of installation and/or handling may create unforeseen situations beyond
the installer’s control which will require case-by-case evaluation of residual risks. We recom-
mend keeping the following in mind:
– Always handle the machine with care to avoid the danger of its falling.
–The packing materials (carton, cellophane, staples, polystyrene, etc.) can cut, wound or cre-
ate hazards if used improperly or handled carelessly. Store such materials out of reach of chil-
dren and irresponsible persons.
– All defects and/or anomalous machine behavior should be reported immediately to autho-
rized installation and/or maintenance personnel.
– Before connecting the machine, check that electrical power supply corresponds to the spec-
ifications on the data plate.
– Should the machine plug not be compatible with your socket, have the plug replaced with
a suitable type by a qualified technician, who should also check that the section of the wires
supplying the power outlet is suitable for the machine power requirements.
Avoid use of multiple-plug adapters and extension cords.
– The ground wire must be connected; the electrical system must meet the standards set by
local safety laws and regulations.
– Avoid extension cords and makeshift connections.
– The machine must be installed only by authorized, qualified personnel.
– Check that the machine components have suffered no damage during shipping; in the case
defects or anomalies are found, interrupt installation and request replacement.
3. INSTALLATION
Libretto AMM-AMMT 23-06-2001 11:30 Pagina 12
To Next Page
Loading...
Need help?
General
