NuStep, Inc. • 5111 Venture Drive, Ann Arbor MI 48108 USA • 800-322-4434
41712- T4/T4r Leg Stabilizer, How To Use Rev A Page 1 of 2
How to Use the NuStep
®
T4/T4r Leg Stabilizer
Call Customer Service with any questions at 800-322-4434.
1. Insert cuff into strap pocket aligning keyhole shapes. Make sure cuff ends lie flat in pocket
2. Insert leg stabilizer into left or right side of seat mount bracket
until snap button pops into place. Note, two leg stabilizers can be
used at the same time in seat mount bracket to align two legs.
3. Position leg stabilizer near user’s leg and depress snap button to
adjust for leg position. Cuff should be located just back from knee.
There are five positions A – E of adjustment.
4. Drop end of strap in between legs and position flap of cuff over
top of leg. Adjust width by pushing grip forward, then slide cuff in
and out to get desired leg alignment. There are ten positions 1 –
10 of adjustment.
5. Wrap strap around leg to secure. Strap does not have to be
overly tight. A pre-wrap towel etc. may be used against bare skin.
6. Check operation by having user begin NuStepping and make
adjustments as required.
To Next Page
General
