Nustep T5 Quick Start Guide

NuStep, Inc. ● 5111 Venture Drive, Ann Arbor MI 48108 USA ● 800-322-4434
53510 T5 Leg Stabilizer Instruction, Rev A
How to Use the NuStep
®
T5 Leg Stabilizer
n
Insert stability arm into left or right side of
seat mount tube on lower front of seat until
snap button pops into place.
o
Position cuff just back from knee.
Drop strap in between user’s legs and wrap
strap around leg to secure. Strap does not
have to be overly tight. A pre-wrap towel
etc. may be used against bare skin.
p
Adjust leg alignment by pushing grip
forward/up, then slide cuff in or out to set
position. There are ten positions (1 – 10)
of adjustment.
q
Leg Stabilizer should swing approximately
45º during operation (as shown). If it is
biased swinging too high or too low outside
the 45º range, depress snap button to
adjust position up or down. There are
three positions (S–M–L) of adjustment.
Verify overall operation by having user start
stepping and making any adjustments.
~45º

Nustep T5 Specifications

General

Type	Recumbent Cross Trainer
Resistance Levels	15
User Weight Capacity	400 lbs (181 kg)
Display	LCD
Power	AC Adapter