To Next PageTo Next Page
Need help?Do you have a question about the NuTone IM-5006 Series and is the answer not in the manual?
General| Brand | NuTone |
|---|---|
| Model | IM-5006 Series |
| Category | Intercom System |
| Language | English |
Details contents of the hardware bag included with the master unit.
Details the types and gauges of wire required for system installation and maximum run lengths.
Specifies system capacity for remote speakers and interference considerations.
Instructions for mounting the master panel to the rough-in frame.
Guidance on connecting system transformers to house power and low-voltage leads.
Instructions for connecting door speaker wires to the control P.C. board.
How to connect the antenna to the main P.C. board for radio reception.
Steps for installing and connecting the optional electronic chime module.
Details on connecting the electro-mechanical chime using NuTone IW-2 cable.
Guidance on connecting the back-up battery to retain system settings and memory.
Instructions for connecting external audio sources like CD players, tape decks, and phonographs.
Final steps to secure the master panel to the rough-in frame and ensure wiring is not pinched.
Explains basic intercom call initiation, volume adjustment, and busy light indicators.
Steps to adjust the radio audio trimpot for optimal sound at remote speakers.
Procedure to adjust the intercom audio trimpot for clear communication between stations.
How to adjust the volume trimpot specifically for the door speaker audio.
Instructions for adjusting the tone generator volume for call, alarm, and feedback tones.
Details various reset levels and troubleshooting steps for system malfunctions.
Addresses causes like wiring proximity to AC power and potential interference sources.
Troubleshooting steps for when select calls fail, including wiring and station code checks.
Covers wiring, power, and transformer checks for lack of audio at remote locations.
Diagnoses issues where remote units work, but the master station is unresponsive.
Troubleshooting wiring, speaker, and volume settings for door communication failures.
Addresses faulty antenna connections and improper antenna installation for radio reception problems.
Troubleshooting for the master station's note mode, related to cassette tape usage.
Guidance on adjusting the program audio trim pot to correct loud radio volume at remote speakers.
Solutions for intercom squealing, including speaker placement and insulation.
Troubleshooting static noise caused by loose ground connections or electrical interference.
Addresses wiring and volume setting problems for optional electronic chime modules.
Troubleshooting wiring and volume adjustments for mechanical chime input.
Guidance on adjusting call tone volume trimpots and tone generator volume.
