NuTone IM-3204 User Manual

RADIO/INTERCOM
SYSTEM
MODEL IM-3204
HOMEOWNER’S
OPERATING
INSTRUCTIONS
Product specifications subject to change without notice.
Printed in China, Rev. 10/2001, Part No. 87840
®
Two Year Limited Warranty
WARRANTY OWNER: NuTone warrants to the original consumer purchaser of its products that
such products will be free from defects in materials or workmanship for a period of two (2)) years
from the date of original purchase. THERE ARE NO OTHER WARRANTIES, EXPRESS OR
IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE.
During this two year period, NuTone will, at its option, repair or replace, without charge, any
product or part which is found to be defective under normal use and service. THIS WARRANTY
DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS OR TUBES. This warranty does not
cover (a) normal maintenance and service or (b) any products or parts which have been subject to
misuse, negligence, accident, improper maintenance or repair (other than by NuTone), faulty
installation or installation contrary to recommended installation instructions.
The duration of any implied warranty is limited to the two year period as specified for the express
warranty. Some states do not allow limitation on how long an implied warranty lasts, so the above
limitation may not apply to you.
NUTONE’S OBLIGATION TO REPAIR OR REPLACE, AT NUTONE’S OPTION, SHALL BE THE
PURCHASER’S SOLE AND EXCLUSIVE REMEDY UNDER THIS WARRANTY. NUTONE SHALL
NOT BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES ARISING OUT
OF OR IN CONNECTION WITH PRODUCT USE OR PERFORMANCE. Some states do not allow
the exclusion or limitation of incidental or consequential damages, so the above limitation or
exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have
other rights, which vary from state to state. This warranty supersedes all prior warranties.
WARRANTY SERVICE: To qualify for warranty service, you must (a) notify NuTone at the
address stated below or telephone 1/800-543-8687, (b) give the model number and part
identification and (c) describe the nature of any defect in the product or part. At the time of
requesting warranty service, you must present evidence of the original purchase date.
Date of Installation Builder or Installer
Model No. and Product Description
IF YOU NEED ASSISTANCE OR SERVICE:
For the location of your nearest NuTone Independent Authorized Service Center:
Residents of the contiguous United States Dial Free 1-800-543-8687
Please be prepared to provide:
Product model number • Date and Proof of purchase • The nature of the difficulty
Residents of Alaska or Hawaii should write to: NuTone Inc. Attn: Department of National Field
Service, 4820 Red Bank Road, Cincinnati Ohio 45227-1599.
Residents of Canada should write to: Broan-NuTone Canada, 1140 Tristar Drive,
Mississauga, Ontario, Canada L5T 1H9.
Rev. 03/2001

NuTone IM-3204 Specifications

General

Brand	NuTone
Model	IM-3204
Category	Intercom System
Language	English

Summary

NuTone Limited Warranty

Warranty Service Procedures and Requirements

Details steps and information required to obtain warranty service for the product.

Product Assistance and Service Contacts

Contact information for customers needing assistance or service for the NuTone system.

Regulatory Compliance and System Reset

FCC Compliance and Modification Warnings

Information regarding FCC rules, potential interference, and warnings against unauthorized modifications.

System Microprocessor Reset Procedure

Instructions on how to reset the system's internal microprocessor to resolve operational issues.

Intercom and Monitor System Operation

Managing Intercom Calls and Door Announcements

Procedures for ending intercom calls and answering incoming calls or door announcements.

Utilizing the Room Monitor Function

Guide on how to use the monitor feature to listen to sounds from selected room locations.

Master Station Intercom Volume Control

Explains the function of the intercom volume control at the master station.

Integration of Optional Accessories

Details on connecting and using optional accessories like door chimes or cassette players.

Station Setup and Intercom Communication

Configuring Station Status Switches

Explanation of how to set station status switches for different operations.

Initiating and Responding to Intercom Calls

Step-by-step instructions for initiating and responding to intercom calls and door talk.

Audio Source and Volume Control

Adjusting Program Audio Levels and Tone

Guide to adjusting audio levels and tone (volume, loudness, treble, bass) for program audio.

Setting System and Remote Station Volumes

Procedures for setting master, remote, and system volume levels for optimal audio.

Master Station Control Panel Functions

Identification and explanation of the various controls on the master station.

Radio and Auxiliary Audio Features

Radio Tuning and Operation

Instructions for selecting AM/FM radio, tuning, and using scan and rapid tune features.

Radio Memory Storage and Recall

Guide on how to store desired radio frequencies into memory and recall them later.

Remote Control of Radio Functions

Enables controlling radio functions like ON/OFF and memory channel advancement from remote stations.

CD/TAPE Auxiliary Audio Input

Procedure for selecting and playing audio from an optional CD or tape player.