NUTOOL MC250N - Technical Specifications

33
GB
PROBLEM POSSIBLE CAUSE REMEDY
The blade does not raise
or tilt smoothly
Sawdust and dirt in the mechanism
Use a brush or suitable vacuum
cleanertoremovedustanddirt.
Relubricate.
The blade does not run
up to speed
Extension reel not of the correct rating
or too long
Use the correct extension reel or
contactanelectrician.
The table saw vibrates
Thetablesawisnotmountedcorrectly.
Check the mounting and secure mounting
fixings.
Thestandorbenchisonanunevenfloor. Secure bench or stand on a level surface
Damagedorbentsawblade. Replacetheblade
The saw does not make
accurate45°or90°cross
cuts
Mitre gauge is out of adjustment Checkandre-adjustthemitregauge
Themotorfailstostart.
The electrical supply is OK
Faulty ON/OFF Switch Have the saw checked by an authorised
servicecentre.
Windingsinthefieldarmatureburnedor
damaged.
Replacethemotorbyanauthorisedservice
centre.
Circuit breaker too sensitive
Possible electrical fault Have the unit
checkedanauthorisedservicecentre.
The motor overheats,
stalls, trips circuit breaker,
blows fuses
Motor overload Feed work piece slower into blade
PoorcoolingSawdustbuilduparoundmotor.
Use a brush or suitable vacuum cleaner to
remove dust and dirt to increase air flow to the
motor.
Windingsburntout
Fuses, Circuit breakers do not have
sufficient capacity
Consultaqualifiedelectrician.
Cutting stalls the motor Dullblade. Replacetheblade
Blade burns the work
piece
Thebladeis“heeling” Seesectiononbladeadjustment.
Blade stops when rip
cutting.
The feed rate is too fast Slowdownthefeedrate.
Theripfenceisnotparalleltotheblade.
ormitregaugegroove.
See rip fence adjustment section
Rivingknifeoutofalignment. See riving knife adjustment section
NOTE. In all cases where an electrical problem occurs.
Isolate the machine from the mains supply and remove the
       
       
exception of replacing carbon brushes all repairs should be
carried out by an authorised service centre.
TECHNICAL SPECIFICATION
Voltage 220-240V~50Hz
Motor 1600W
No load speed 4800min
-1
Blade size 250Ø
MaxCut@90° 85 mm
MaxCut@45° 55 mm
Sound Pressure Level
L
PA96,2dB(A)
Sound Power Level
L
WA109,2dB(A)
Weight 19,4kg