14
GB
Be aware of the high torque reaction when drilling especially
whendrillingmasonry.
DO NOT try to change any of the selector switches while the
motorisrunning.Doingsocoulddamagethemachine.
DO NOT attempt to modify the machine or its accessories in
anyway.
DONOTforcethemachine,letthemachinedothework.This
will reduce the wear on the machine and cutter and increase its
efficiencyandoperatinglife.
Do not use this product with any attachment designed for mixing
mortar, concrete, or plaster. Or for any other type of mixing
operation.
- Ifpossible,alwaysuseclampsoravicetoholdyourwork.
- Alwaysswitchoffbeforeyouputthedrilldown.
- Whenusingthedrill,usesafetyequipmentincludingsafety
glasses or shield, ear defenders, and protective clothing
including safety gloves. Wear a dust mask if the drilling
operationcreatesdust.
-
1. Before using the charger, read all the instructions and
cautionary markings on the charger and battery pack as well
astheinstructionsonusingthebatterypack.
2. Only charge your batteries indoors as the charger is
designedforindooruseonly.
3. If the battery pack is cracked or damaged in any
otherway,donotinsertitinthecharger.Thereisadanger
ofelectricshockorelectrocution.
4. Do not allow any liquid to come into contact with
thecharger.Thereisadangerofelectricshock.
5. The charger and battery packs supplied with it are
specifically designed to work together. Do not attempt to
charge the battery pack with any other charger than the one
supplied.
6. Do not pull on the power cord to disconnect it from the
mainssupplysocket.
7. Donotusethechargerifithasbeensubjectedtoaheavy
knock, dropped or otherwise damaged in any way. Take
the charger to an authorised service centre for a check or
repair.
8. Do notdisassemblethecharger.Takeit to anauthorised
servicecentrewhenserviceorrepairisrequired.Incorrect
re-assemblymayresultintheriskoffire,electricshockor
electrocution.
9. Toreducetheriskofanelectricshock,unplugthecharger
from the power supply before attempting to clean it.
Removingthebatteryalonedoesnotreducetherisk.
1. The battery pack for this tool has been shipped in a low
chargecondition.Youshouldchargethebatterypackfully
beforeuse.
2. Do not incinerate the battery pack even if it is seriously
damagedorcannolongerholdacharge.Thebatterypack
canexplodeinafire.
3. Asmallleakageofliquidfromthebatterypackmayoccur
under extreme usage or temperature conditions. This
doesnotnecessarilyindicateafailureofthebatterypack.
However, if the outer seal is broken and this leakage comes
into contact with your skin wash the affected area quickly
withsoapandwater.Iftheleakagegetsinyoureyesflush
youreyeswithcleanwaterforaminimumof10minutesand
seekimmediatemedicalattention.Informthemedicalstaff
thattheliquidisa25-35%solutionofpotassiumhydroxide.
4. Neverattempttoopenthebatterypackforanyreason.Ifthe
plastic housing of the battery pack breaks open or cracks,
immediatelydiscontinueitsuseanddonotrechargeit.
5. Donotstoreorcarryasparebatterypackinapocketor
toolbox or any other place where it may come into contact
withmetalobjects.Thebatterypackmaybeshort-circuited
causingdamagetothebatterypack,burnsorafire.
Nicad battery charging rates are determined by the time taken
to fully charge the battery and are determined by the charge
current. The three most commonly used charging rates are
typically:
The charging rates for charge batteries can vary between
30minutesand90minutes.Thechargingrateforthebattery
supplied with a cordless power tool is stated in the product
manual.
The charging rates for charge batteries are between 3
Hoursand5Hours.
The charging rates for charge batteries are between 7
Hoursand9Hours.
WhencharginganewNiCadbatteryitshouldbefullydischarged
followed by a full charge for the charging rate for the battery as
statedintheproductmanualplus30minutes.Thisshouldthen
be followed by a full discharge and a further full charge for the
charging rate for the battery as stated in the product manual
plus30minutes.Thisprocedurewillconditionthebatteryand
equalisethecellvoltages.Followingthisprocedurewillensure
theoptimumoperationofthebattery.
When repeatedly using the charger to charge a number of
batteries always allow the charger to cool down before charging
anotherbattery.Itisrecommendedthatthecoolingdownperiod