BEFORE BLENDING:
UNIT ASSEMBLED BUT
CANNOT POWER ON
If the unit is not operating, this
may be due to parts not being
fully locked in place. Check to
make sure the attachment you
are using is locked tightly onto
the main body of the blender.
DURING OPERATION:
BLENDER STOPS
STUCK, NOT BLENDING,
NOT OPERABLE
In the unlikely event that the
blending arm or whisk gets
stuck and blending stops,
release the power button, wait
for the unit to shut o, and look
at your mixture (the items
you’re processing).
If the problem seems to be an
overly thick mixture that caused
the blade to stop moving, try
adding water or other liquid
Troubleshooting.
to soften the mixture, or try
separating the mixture by
hand, or removing some of the
mixture. Then try blending or
whisking again on the loosened
or thinned out mixture.
Also check the cutting area
of your attachment (blade or
whisk) to see if there is residue
or food particle buildup; if so,
rinse o with warm water, then
try blending again.
If the blender still won’t
operate, turn it o, unplug
it, disassemble it, then
reassemble it. After reassembly,
power on the blender and
see if normal function has
been restored.
OVERHEATING
To avoid overheating, allow
the Immersion Blender to cool
down for at least 5 minutes
between uses.
21
To Next Page
Loading...
