19
Stubborn clean up:
If ingredients get stuck to the
NutriBullet
®
cups or easy-twist
extractor blades, here’s an
easy cleanup solution: fill the
vessel with room temperature
(21°C/70°F or less) water to its
MAX line and add 1-2 drops of
dish soap. Twist on the easy-
twist extractor blade and blend
on the motor base for 20-30
seconds. This should loosen the
debris enough to scrub it away
with soap and water.
How to store:
Store the NutriBullet PRO
®
1000
upright. Do not place anything
on top of it. Store remaining
pieces in a safe place where
they will not be damaged and
won’t cause harm.
WARNING: NEVER store the easy-
twist extractor blade on the motor
base without a NutriBullet
®
cup as
the exposed blades pose a serious
laceration hazard.
reduce buildup of residue. If
food particles get stuck, use
a small brush or sponge to
target and dislodge them.
• Do not remove any
components of the easy-twist
extractor blade; this can result
in permanent damage to the
blade, resulting in leakage
when blending. If, over time,
the easy-twist extractor blade
becomes loose or damaged,
you may order a new easy-
twist extractor blade at
nutribullet.com or contact
Customer Service.
• Dry the easy-twist extractor
blade completely after
every use.
• Regularly check the
condition of the bottom
of the blade for cracking
or breakage. If damaged,
replace easy-twist extractor
blade immediately to prevent
possible personal injury.
NUTRIBULLET
®
CUPS
& TOGO LIDS:
These items are TOP RACK
dishwasher-safe. We recommend
rinsing and briefly scrubbing
them with a dish brush to remove
any remaining debris before
placing in the dishwasher. NEVER
use the sanitize cycle to wash the
cups — heat this high can warp
the plastic.
Replacement parts.
To order additional parts and
accessories, please visit our
website at nutribullet.com or
feel free to contact Customer
Service.
To Next Page
Loading...
