-74-
SET UP MODE
The set up mode is used • to set the alarm level,
• to lock the kepad,
• to switch the audible alarm off when a dose is administered,
• to switch the light of the LCD permanentl on when connected to the mains,
• to enable connection with a Nurse call or Patient Data
Monitoring Sstem (PDMS).
This set up mode ma onl be entered b healthcare professionals and authorised personnel trained to use
this application of the pump.
The patient or his/her relatives without permission of the phsician, dietician, nurse or other licensed practi-
tioner, ma not change the settings of the set up mode.
TO SET THE ALARM LEVEL
Switch the pump “on” while holding the “+” ke down. The pump enters the set up mode.
First the alarm level can be set:
“BEEP HIGH” (+) or “BEEP LOW” (-)
Use the “+” or “-” ke to change the setting from “high” to “low” or from “low” to “high”.
TO
LOCK THE KEyPAD
Press in the set up mode the “FILL SET” ke to switch to the next setting:
“UNLK” the kepad (-) or “LOCK” the kepad (+). In the “LOCK” mode the feeding program of the pump
can no longer be changed.
Use the “+” or “-” ke to change the setting from “lock” to “unlk” or vice versa.
ON/OFF
&
d
Beep high
+
Beep low
-
+
2 sec 2 sec
FILL SET
d
Lock
Unlk
-
+
ER01 - ER99
No plug smbol visi-
ble, while the pump
is connected to the
mains.
Condition
LOCK
• The self test detected an electronic
error
• The wall outlet doesn’t work.
• The adaptor is damaged.
Cause
• Onl the current feeding
schedule is allowed for this patient.
Another feeding program is not
allowed b our healthcare profes-
sional.
• Turn the pump “off”, make sure the pump door is closed
and switch the pump back “on”. If the error persists,
contact our healthcare provider or refer the pump to
service.
• Connect the pump to another wall outlet.
• Contact our healthcare professional or
Nutricia subsidiar to replace the adaptor.
Correction
• The programming feature is blocked in the set up mode
of the pump. Ask our healthcare professional to modif
this setting.
UK-IE
ZMNL400336_AW.indd 76 3/18/10 3:47:43 PM