Nutricia Flocare Infinity - Operating Instructions; Pump Set Insertion; Switching Pump On and Off; Hold Mode Operation

-68-
OPERATING INSTRUCTIONS
INSERTION OF THE FLOCARE
®
INFINITy
™
PUMP SET
• Connect the set to the feed container as instructed on the packaging of the Flocare
®
Infinit
™
pump set.
Remove the dust cap from the step connector.
• The Flocare
®
Infinit
™
pump sets are equipped with an “automatic free-flow protection”, as a consequence
the set has no roller clamp.
Fill the pump set completel with feed b gentl pinching on the side of the cassette that is marked with a
drop (point A on figure 5a) or fill the pump set with help of the pump (see paragraph: filling the pump set).
• Open the pump door b pressing up on the lower wall and rotating the door upwards at the same time
(see figure 5b).
• Position the looped section of the silicone tubing around the rotor.
Stretching lightl, (see figure 5c) seat the cassette into the pump (see figure 5d).
• Close the pump door.
SWITCHING “ON”
For proper pump operation, make sure the pump door is closed prior to switching the
pump on. Press the “ON/OFF” ke for 2 seconds.
The pump beeps and carries out a short self test, showing the pump serial number
in 8 digits. Verif that all displa segments and smbols are active as shown in figure
6 (see next page).
The pump displas the total volume delivered since the memor was cleared and
switches in the hold mode read for programming.
SWITCHING “OFF”
Press the “ON/OFF” ke and keep it pressed for 2 seconds. A continuous alarm will be
heard and the pump switches off.
The feeding program (installed parameters) and total volume administered since the
last clearance will be retained in the pump’s memor.
If the pump shuts down due to low batter voltage, the memor will be retained for
24 hours.
“HOLD” MODE
To temporaril pause the pump, or switch into “hold” mode whilst operating, press the
“START/STOP” ke once. Three beeps are heard and the run smbol disappears.
The programmed flow rate (ml/h), volume (DOSE=VOL) and the administered volume
(ml) are retained.
The “hold” mode is used to temporaril stop the flow of feed:
• to change the feeding program (installed parameters),
• to change the feed container,
ON/OFF
ON/OFF
START/STOP
UK-IE
ZMNL400336_AW.indd 70 3/18/10 3:47:42 PM