NuWave OXYPURE 47003 - Filter Maintenance and Sensors; Filter Replacement Alerts; Changing the Air Filters

nuwavenow.com | 13
CLEANING & MAINTENANCE
Odor Sensor
Top Vent
TOP
BOTTOM
Inow Vent
Cleaning the Odor Sensor Opening
The Odor Sensor is located on the upper
right side corner of the OxyPure underneath
the small grill opening.
• Keep the Odor
Sensor clear of
dust and debris
by cleaning with
a vacuum brush
attachment.
•
DO NOT
tamper or spray
inside or near
the odor sensor. this may cause
the sensor to malfunction and void
the warranty.
The CLEAN FILTER 2 light will turn green
in about 3 months to alert you that the Bio-
Guard Filter SHOULD be cleaned to maintain
optimal performance. When the light turns red
(after about 6 months), the Bio-Guard Filter
MUST be cleaned.
1. Remove the Filter Slot Cover in the rear
of the OxyPure using its built-in handle.
2. Slide out the filters that need cleaning or
replacement.
3. Allow the
washable filters
to dry completely
before you reinstall
them.
• Never place a
wet filter into
the OxyPure.
• Ensure the
Filter Slot
Cover is properly aligned and secure
when reattaching.
2
4
Bio-Guard
™
Filter
HEPA/Carbon
Filter
4
3
2
1
The REPLACE FILTER 4 light will turn
green after 6 months to alert you that you
SHOULD consider changing the HEPA/
Carbon filter. When the light turns red (after
about 12 months), you MUST replace
the filter. Depending on your operating
environment, you may wish to replace the
Filter more frequently.
Changing the Filters
The filters inside the Filter Slot need to
be changed or cleaned on schedule to
help your OxyPure maintain optimum
performance.
ON THE CONTROL PANEL:
Filter Replacement
Indicator
ODOR
NO
ODOR
STRONG
ODOR
REPLACE
FILTER 4
CLEAN
FILTER 2
DIRTY
AIR
ON THE CONTROL PANEL:
Filter Replacement
Indicator