NuWave OxyPure Zero E500

To Next Page

To Previous Page

Customer Service:

For Amazon Purchases: support@nuwavenow.com ● For All Other Purchases: help@nuwavenow.com

Air Filter Assembly

When maintaining the lters, unplug the unit and

open the Filter Access Panel. You will see that the

order of the lters, from the outside in, is as follows:

Stainless-Steel Prefilters

Bio-Guard

filters

Bio-Guard

360 filter

Cleaning and Maintenance

The OxyPure

is easily movable. Before moving your OxyPure, turn it off and unplug it from the outlet. Your settings will be saved and will

automatically activate next time the unit is turned on.

Filter Maintenance Indicators

To alert you to the need to clean your Bio-Guard lters, there are LED Filter Indicators beneath the TIMER and

TURBO buttons. These will light up based on the length of operation as follows:

• The Clean Filter 2 light will turn green in about 3 months to alert you that the Bio-Guard lter SHOULD be

cleaned to maintain optimal performance (NuWave Recommendation). When the light turns red (after about

6 months), the Bio-Guard lter MUST be cleaned and thoroughly dried. Once cleaned and thoroughly dried,

press and hold TIMER for 2 seconds until a beep is heard to reset the Filter Indicator for Filter 2.

• The Clean Filter 3 light will turn green in about 3 months to alert you that the Bio-Guard 360 lter SHOULD be

cleaned to maintain optimal performance (NuWave Recommendation). When the light turns red (after about 6

months), the Bio-Guard 360 lter MUST be cleaned. Once cleaned and thoroughly dried, press and hold

TURBO for 2 seconds until a beep is heard to reset the Filter Indicator for Filter 3.

Maintaining the Filters

The lters need to be cleaned on schedule to help the unit maintain optimum performance.

1. Remove the Filter Access Panel in the rear of the OxyPure

using its built-in handle.

2. Slide out the lters that need cleaning.

3. Always allow the washable lters to dry completely, out of direct sunlight, before you reinstall them. Never place a wet lter into the

OxyPure.

4. Close the Filter Access Panel. If the panel is not properly closed, the POWER button will blink red and the unit will not power on.

NuWave OxyPure Zero E500 - Page 3