CAUTION
Unplug the OxyPure
®
from the power source before inserting or removing any parts or attachments and before cleaning.
Cleaning & Maintenance
Cleaning the Odor Sensor
The Odor Sensor is located on the upper right side corner of the
OxyPure underneath the small grill opening. Dust and debris may
accumulate. Use a vacuum brush attachment and gently brush
the grill.
Be careful when using sprays. DO NOT spray on or close to the
odor sensor. Spray at least 3 feet away and not in the direction of
the Odor Sensor.
Cleaning the Stainless Steel Pre-Filter
1. Use a vacuum with a brush
attachment.
2. Clean the Filter with warm soapy
water.
3. Rinse the Filter thoroughly and
remove any soap particles.
4. Allow the Filter to dry completely
BEFORE placing it into slot using
the tabs.
Cleaning the Air Quality Sensor
The Air Quality Sensor is located on the
back.
1. Open the panel (Sensor Cover).
2. Using a dry cotton swab or small,
soft brush, gently remove
any dirt or dust from the Sensor.
3. For heavier buildup on the Sensor,
wipe it with a slightly wet cotton
swab.
4. Remove any moisture with a dry cotton swab.
• The Air Quality Sensor requires regular cleaning (approx.
every 3 months) for the OxyPure to operate efficiently.
• If your OxyPure is set up in an area with high dust
accumulation, more frequent cleaning of the Filter Sensor is
needed.
• Do not use the cotton swab on any part or area other than
the Air Quality Sensor.
Filter 2/3: Cleaning the Bio-Guard
®
Filter
1. Remove the Filter.
2. Spray the Filter with a mild degreaser or
dish soap and let it sit for 2-3 minutes.
3. Submerge the Filter in warm water,
shake, and remove.
4. Repeat this process until the Filter water
is clean.
5. Rinse the Filter with warm water.
Repeat as needed.
6. Dry the Filter completely before inserting
into slot .
Note: The Bio-Guard™ Filter may discolor
and retain odor after prolonged exposure
to thick smoke and strong odors. When
exposured will require more frequent
2
1
Note: DO NOT immerse the OxyPure in water. Clean with a damp
sponge or cloth and wipe dry. Make sure all parts and covers are securely
attached.
SCAN QR CODE TO WATCH OUR VIDEO ON
HOW TO CLEAN THE FILTERS
Cylindrical
Bio-Guard
®
Filter
Bio-Guard
®
Filter (2)
Stainless Steel Prefilter (2)
Air Quality Sensor
Odor Sensor
OXYPURE ZERO AIR PURIFIER
Clean Filter Schedule
3 Months Yellow Routine cleaning.
6 Months Orange Should be cleaned for continued
efficiency.
12 Months Red Clean for optimal performance
especially if the first 2 were missed.
To Previous Page
Loading...
