30 | MEC 5000, 6500 & 8000/P
www.natvac.com | 800.253.5500
8. Locate the replacement
seals and install them in
the endplates with the seals
positioned back to back.
Replace the seal in the bearing
cover with the lip facing outward.
9. Lubricate and install the
bearings in the endplates.
10. Locate two pieces of threaded
rod 3/8-18 thd. to use as
guides and screw them into the
two top holes in the housing.
Locate proper number of gaskets
and slide on the threaded rods.
Do not use any gasket sealer.
11. Lubricate the housing bore.
12. Lubricate seal sleeve and drive
the proper endplate on the
input end of the rotor.
To Next Page
Loading...