MEC 5000, 6500 & 8000/P | 33www.natvac.com | 800.253.5500
21. At this point you should be able
to turn the pump by hand.
22. Lubricate and reinstall the front
outboard bearing and bearing
cover.
Reinstall the oil pump drive key, oil
pump mount assembly, and gaskets
to the pump.
Be sure to line up the oil pump drive
key and the oil pump shaft prior
to tightening the assembly to the
pump.
23. Connect the oil lines to the oil
pump.
The pump is now ready to run.
24. Start the pump at a slow RPM
and allow to run for a few
minutes until oil can be seen in
the lines or dripper.
Allow to run for a few more minutes.
The pump is now ready to go to
work.
To Next Page
Loading...