During periods of lightning activity, do not work on the equipment or connect
or dis connect cables.
Copper Cable Connecting/Disconnecting
Some copper cables are heavy and not flexible, as such, they should be
carefully attached to or detached from the connectors. Refer to the cable
manufacturer for spe cial warnings and instructions.
Equipment Installation
This equipment should be installed, replaced, or serviced only by trained and
qualified personnel.
Equipment Disposal
The disposal of this equipment should be in accordance to all national laws and
regula tions.
Local and National Electrical Codes
This equipment should be installed in compliance with local and national
electrical codes.
Hazardous Radiation Exposure
Caution – Use of controls or adjustment or performance of procedures
other than those specified herein may result in hazardous radiation
exposure.For products with optical ports.
CLASS 1 LASER PRODUCT and reference to the most recent laser
standards:
IEC 60 825-1:1993 + A1:1997 + A2:2001 and EN 60825-1:1994+A1:1996+
A2:20
Installation Procedure Overview
The installation procedure involves the following steps:
Ste
p
Procedure Direct Link
1
Check the system’s hardware and software
requirements.
Refer to System Requirements
2
Pay attention to the airflow consideration
within the host system
Refer to Airflow Requirements
To Next Page
Loading...
