Installing WinOF-2 Driver
The snapshots in the following sections are for illustration purposes only. The installation
interface may slightly vary, depending on the used operating system.
This section provides instructions for two types of installation procedures, and both
require administrator privileges:
Attended Installation
An installation procedure that requires frequent user intervention.
Unattended Installation
An automated installation procedure that requires no user intervention.
Attended Installation
The following is an example of an installation session.
1. Double click the .exe and follow the GUI instructions to install MLNX_WinOF2.
2. [Optional] Manually configure your setup to contain the logs option (replace
“LogFile” with the relevant directory).
3. [Optional] If you do not want to upgrade your firmware version (i.e.,
MT_SKIPFWUPGRD default value is False).
4. [Optional] If you do not want to install the Rshim driver, run.
(or a similar) error message: “The installation package is not
supported by this processor type. Contact your vendor”
MLNX_WinOF2_<revision_version>_All_Arch.exe /v"/l*vx [LogFile]"
MLNX_WinOF2_<revision_version>_All_Arch.exe /v" MT_SKIPFWUPGRD=1"
To Next Page
Loading...
