The following instructions and pictures are provided to assist you with the installation of the EVGA GTX™ 1080/GTX™ 1070
FTW Hybrid Cooling Kit on compatible GTX™ 1080/GTX™ 1070 FTW graphics cards. Please be careful when install the FTW
Hybrid Cooling Kit; there are several very small screws used, which can be easily stripped.
Please keep your original cooling solution, including screws. If you ever need to submit a warranty claim, EVGA requires
that you reinstall the original cooling solution prior to sending your product in for warranty.
Steps to install the FTW Hybrid Cooling Kit include removing the backplate, the original heatsink/fan, and the original
baseplate before installing a new baseplate, thermal pads on the memory chips and VRM, cleaning the GPU, and installing
the waterblock and shroud. This manual will explain the process in much greater detail below. The FTW Hybrid Cooling Kit is
officially-compatible with the graphics cards listed below:
GTX™ 1080 FTW 08G-P4-6286-KR
GTX™ 1080 FTW DT 08G-P4-6284-KR
GTX™ 1070 FTW 08G-P4-6276-KR
GTX™ 1070 FTW DT 08G-P4-6274-KR
Before you begin:
Please look at the table above to confirm that your graphics card is compatible with the FTW Hybrid Cooling Kit. If your
graphics card model is not on the list, do not attempt to install the FTW Hybrid Cooling Kit. If you have questions, please call
EVGA Customer Support at (888) 881-EVGA, or e-mail Support at support@evga.com.
Please follow the instructions below:
1) Remove the screws on the back of the card to separate the backplate from the card. The image below will outline which
screws will need to be removed.
To Next Page
Loading...
