Chapter 2.
Hardware and Software Installation
Hardware Installation
Please refer to the following steps.
* If your mainboard has any onboard VGA capability,
disable it before installation.
1. Remove all previous video card driver installations.
2. Shut down the computer and remove the computer case panels.
3. Remove any existing graphic card installed on your mainboard.
4. Press the new card into the AGP slot (usually a brown colour) and make
sure it is firmly installed. Then secure the card with a bracket screw.
5. Insert any other cards that needs to be installed, attach all the cables,
install all other devices, and close the computer case panels.
6. Turn on the computer. You are now ready to install the driver. Proceed to
the software installation section.
* This figure is for reference only.
Your system will vary according to brand and model.
To Next Page
Loading...
