To Previous Page

FCC Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two condition

.(1).this device may not cause harmful interference.

(2).this device must accept any interference received, including interference that may cause undesired operation

Warning:

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, used and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference in to radiate communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

l Reorient or relocate the receiving antenna

l Increase the separation between the equipment and receiver.

l Connect the equipment into an outlet on a circuit different form that to which the receiver in connected.

l Consult the dealer or an experienced radio/TV technician for help.

Notice:

(1) An Unshielded-type power cord is required in order to meet FCC emission limits and also to prevent interference to the nearby radio and television

reception. It is essential that only the supplied power cord by used.

(2) Use only shielded cables to connect I/O devices to this equipment.3

(3) Changes or modifications not expressly approved by the party responsible for compliance could void the use’s authority to operate the equipment.

Trademark Acknowledgments

All brand names and trademarks are the property of their owners.