Jetson Developer Kit Support Guide | Page 2
JETSON DEVELOPER KIT SUPPORT GUIDE
SAFETY INFORMATION
NVIDIA products are designed to operate safely when installed and used according to the product instructions and general safety
practices. The guidelines included in this document explain the potential risks associated with equipment operation and provide
important safety practices designed to minimize these risks. By carefully following the information contained in this document, you can
protect yourself from hazards and create a safer environment.
This product is designed and tested to meet IEC60950-1, the Standard for Safety of Information Technology Equipment. This also covers
the national implementation of IEC60950-1 based safety standards around the world e.g. UL60950-1. These standards reduce the risk
of injury from the following hazards:
> Electric shock: Hazardous voltage levels contained in parts of the product
> Fire: Overload, temperature, material flammability
> Mechanical: Sharp edges, moving parts, instability
> Energy: Circuits with high energy levels (240 volt amperes) or potential as burn hazards
> Heat: Accessible parts of the product at high temperatures
> Chemical: Chemical fumes and vapors
> Radiation: Noise, ionizing, laser, ultrasonic waves
Retain and follow all product safety and operating instructions. Always refer to the documentation supplied with your equipment.
Observe all warnings on the product and in the operating instructions.
Note: Read all safety information below and operating instructions before using the Jetson Developer Kit to avoid injury.
!
WARNING: FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS COULD RESULT IN FIRE, ELECTRIC SHOCK OR OTHER
INJURY OR DAMAGE. ELECTRICAL EQUIPMENT CAN BE HAZARDOUS IF MISUSED. OPERATION OF THIS PRODUCT,
OR SIMILAR PRODUCTS, MUST ALWAYS BE SUPERVISED BY AN ADULT. DO NOT ALLOW CHILDREN ACCESS TO THIS
ELECTRICAL PRODUCT AND DO NOT PERMIT THEM TO HANDLE ANY CABLES.
To reduce the risk of bodily injury, electric shock, fire, and damage to the equipment, observe the safety labels included on the equipment.
ANTISTATIC PRECAUTIONS
> Avoid working in areas where static electricity can build up, such as carpeted areas.
> To minimize the possibility of a static charge harming the hardware, always use a properly grounded anti-static wrist strap when
working with the Jetson Developer Kit.
> In addition, always discharge any residual static electricity that may be present by touching a non-conducting edge of the kit first.
Never touch components, pins, or connectors without the wrist strap attached and grounded.
176-0325-001-jetson-tx1-tx2-developer-kit-support-guide-r6.indd 2 10/25/18 2:09 PM
To Next Page
Need help?
General
