EasyManuals Logo

NVX MVPA1 User Manual

NVX MVPA1
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
7
NVX MVP
TROUBLESHOOTING
TROUBLE SOLUTION
Power LED on amplier is not lit when
source is turned on
Verify remote turn-on wire has suffcient voltage
Make sure power (+12V), ground (Gnd) and remote (Rem) connections are secure
Check amplier fuse and in-line fuse
Make sure power wire has suffcient voltage
Power LED is on, but no output from
speakers
Check RCA/ High-Level Speaker connections to ensure amplier is receiving signal
Check gain on amplier
Check volume on source unit
Hearing engine noise through speakers
Turn the source off, then disconnect the RCA’s or speaker-level harness. If the
noise stops, check all wiring and equipment connected to the amplier and check
to make sure you have a solid ground connection. If the noise continues, contact
NVX tech support.
Amplier output distorted
Make sure source output is not distorted
Check the input sensitivity to make sure gain is not set to high.
Red LED protection indicator is lit
Make sure amplier has proper ventilation
Speakers are wired to the correct impedance for the application
Check to see if the speaker is short-circuited due to faulty connection or exposed wire.
Make sure the speaker is crossover in the correct range.
Make sure signal input is not shorted due to faulty connection or exposed wire.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NVX MVPA1 and is the answer not in the manual?

NVX MVPA1 Specifications

General IconGeneral
BrandNVX
ModelMVPA1
CategoryAmplifier
LanguageEnglish

Related product manuals